This rear driveshaft prop shaft assembly is a direct-fit replacement driveshaft for 1999-2004 Toyota Tacoma L4 2.7L RWD models, transferring torque from the transmission to the rear differential so your truck keeps pulling under load.
This rear driveshaft prop shaft assembly is built to replace a worn, bent, or vibrating factory driveshaft on 1999-2004 Toyota Tacoma L4 2.7L RWD trucks. It carries rotational power from the transmission output to the rear axle, keeping acceleration smooth and drivetrain noise down. A solid choice for daily drivers, work trucks, and DIY mechanics restoring a Tacoma driveline.
| Position | Rear |
| Engine | L4 2.7L |
| Drivetrain | RWD |
| Vehicle Fit | 1999-2004 Toyota Tacoma |
| Type | Driveshaft Prop Shaft Assembly |
Q: Will this fit my 4×4 Tacoma? A: No, this assembly is listed for rear-wheel-drive L4 2.7L models only. Confirm your drivetrain configuration before ordering.
Q: Are U-joints included? A: The driveshaft ships as a complete assembly with U-joints already installed for a direct replacement. Reuse your existing hardware where specified.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.