This silicone hose elbow coupler joiner pipe connects two 2.5 inch pipes at a 90 degree angle, with a 102mm leg length for tight routing in intake, intercooler, and charge pipe setups.
This silicone hose elbow coupler joiner pipe joins two 2.5 inch sections at a 90 degree bend, giving intake and charge pipe builds a smooth, reinforced turn where straight couplers cannot fit. The 102mm leg length on each side provides enough material for secure clamping on both ends of the bend. The silicone elbow coupler is suited to intercooler piping, turbo intake routing, and general boost tube fabrication in 2.5 inch systems.
| Inlet Diameter | 2.5 inch |
| Outlet Diameter | 2.5 inch |
| Bend Angle | 90 degrees |
| Leg Length | 102mm |
| Material | Silicone |
Q: What size clamps work with this 2.5 inch elbow? A: Use clamps sized for a 2.5 inch inside diameter hose, checking the wall thickness so the clamp secures the bead without cutting into the silicone. Wide band clamps are a common choice for silicone couplers.
Q: Can this elbow handle boost pressure? A: Multi-ply silicone elbows of this type are built for charged air and intake plumbing under normal boost levels. Check that the bend is supported and not stretched during installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.