208-4303 head studs are replacement fasteners designed to secure the cylinder head to the block on Honda and Acura B-series DOHC VTEC engines, offering a stronger clamping alternative to original head bolts.
These head studs for Honda and Acura B18C and B18C1 DOHC VTEC engines replace the factory head bolts with a reusable stud-and-nut design that improves clamping consistency across the cylinder head. The 208-4303 head studs are aimed at engine builders, swap enthusiasts, and repair shops working on GSR and B18 platforms that need reliable head sealing under load. Each stud is machined to hold torque evenly so the head gasket stays compressed across the deck surface.
| Part Number(s) | 208-4303 |
| Material | Alloy steel |
| Engine Family | Honda Acura B-series DOHC VTEC |
| Fitment | B18C, B18C1, B18 |
Q: Do these studs need a specific torque sequence? A: Yes, head studs on B-series engines should be torqued in stages following the factory sequence and the torque spec for the studs being installed. Always consult the head gasket and stud manufacturer guidance for the final number.
Q: Can these be reused after a teardown? A: Stud-and-nut designs like the 208-4303 set are typically inspected and reused if they have not stretched or been damaged. Check length and thread condition before reinstalling.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.