This front brake caliper is a replacement hydraulic brake component for Can-Am Commander 800, 800R, 1000, 1000R, and Maverick 1000 side-by-side models, squeezing the brake pads against the rotor to deliver reliable stopping power on the front wheel.
This front brake caliper is built as a direct replacement for the factory unit on Can-Am Commander and Maverick side-by-sides. It houses the brake pads and uses hydraulic pressure from the master cylinder to clamp the rotor, giving you dependable front braking for trail riding and utility work. It suits owners of Commander 800, 800R, 1000, 1000R, and Maverick 1000 machines replacing a leaking or seized caliper.
| Type | Front Brake Caliper |
| Position | Front |
| Actuation | Hydraulic |
| Compatibility | Can-Am Commander 800, 800R, 1000, 1000R, Maverick 1000 |
Q: Do I need to bleed the brakes after installing this caliper? A: Yes, any time a caliper is replaced or the brake line is opened, air enters the system and must be bled out through the bleeder fitting. Use fresh DOT brake fluid and pump the lever until it feels firm.
Q: Is this an original Can-Am part? A: No, this is an aftermarket replacement caliper designed to fit the listed Commander and Maverick models. It mounts using the factory caliper location and hardware.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.