This 9B-116 trim cylinder pin cap bushing hardware kit for MerCruiser Alpha 1 Gen 2 contains the pin, cap, bushing and related hardware needed to service the trim cylinder mounting points on your stern drive, replacing worn components so the drive trims smoothly.
This 9B-116 trim cylinder pin cap bushing hardware kit for MerCruiser Alpha 1 Gen 2 supplies the pin, cap, bushing, and small mounting hardware used at the trim cylinder pivot points. It restores a solid, rattle free connection so the leg holds trim angle and moves through its range the way it should. Boat owners and marine mechanics rebuilding or refreshing a Gen 2 Alpha drive will find this trim cylinder pin cap bushing hardware kit a practical, direct service option.
| Part Number(s) | 9B-116 |
| Type | Trim cylinder pin, cap and bushing hardware kit |
| Compatibility | for MerCruiser Alpha 1 Gen 2 |
| Contents | Pin, cap, bushing and mounting hardware |
Q: Do I need to remove the drive to fit this kit? A: Most trim cylinder pin and bushing work can be done with the drive in place, though access is easier with the boat out of the water. Check your service manual for the exact procedure on your Alpha 1 Gen 2.
Q: Why replace the bushings if the pin still looks fine? A: Worn bushings let the pin move, which causes noise, sloppy trim, and extra load on the cylinder. Replacing the bushing with the pin and cap keeps the pivot tight.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.