This set of eight galvanized swivel bunk board brackets fits 10 inch vertical bunk boards, letting you angle and secure boards to bolster supports on boat trailers for proper hull support.
These galvanized swivel bunk board brackets provide adjustable mounting points for 10 inch vertical bunk boards on boat trailers. The swivel design lets you tilt each bracket to match hull contours, so boards sit flush against the boat instead of pressing on a single edge. Sold in an eight piece set, they cover a full trailer bunk setup in one order. These swivel bunk board brackets are a practical choice for trailer owners replacing rusted or fixed mounts.
| Quantity | 8 pieces |
| Board Size | 10 inch vertical bunk boards |
| Type | Swivel bunk board bracket |
| Finish | Galvanized |
| Application | Boat trailer bolster and bunk mounting |
Q: Do these brackets work with any bunk board width? A: They are sized for 10 inch vertical bunk boards and bolster mounts, so check your board dimensions before ordering. A: Using the wrong board size can leave the bracket loose or misaligned.
Q: Is the swivel adjustable after installation? A: Yes, the swivel lets you set the board angle during mounting so it matches your hull. A: Tighten all hardware once the angle is set to keep it fixed in place.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.