Home › Suspension, Steering & Wheels › Ball Joints & Tie Rods › 2x Front Lower Control Arm Driver Passenger For Subaru XV Crosstrek 2013-2017
Ball Joints & Tie Rods

2x Front Lower Control Arm Driver Passenger For Subaru XV Crosstrek 2013-2017

Original price was: $141.09.Current price is: $42.33.
🚚 Free Shipping over $59
✓ Premium Quality
🔒 Secure Payments
↻ Money Back Guarantee
SKU: ZZ3Q01093
CATEGORY: Ball Joints & Tie Rods
Description

Front Lower Control Arm for Subaru XV Crosstrek (Pair)

This pair of front lower control arms, one for the driver side and one for the passenger side, connects the front suspension to the chassis for stable steering and even tire wear on your Subaru XV Crosstrek.

Overview

These front lower control arm assemblies are direct-fit replacement components for the Subaru XV Crosstrek, sold as a two-piece set covering driver and passenger sides. Each front lower control arm restores proper suspension geometry and helps eliminate clunks, wandering, and uneven tire wear. A solid choice for DIY mechanics and shops servicing Crosstrek models from 2013 through 2017.

Built For Performance

  • Constructed from stamped steel for strength under daily driving loads
  • Pre-installed bushings reduce vibration and road noise
  • Ball joint mounting point machined for precise alignment
  • Sold as a matched pair for both front sides
  • Corrosion-resistant finish extends service life

Fits These Machines

  • for Subaru XV Crosstrek 2013
  • for Subaru XV Crosstrek 2014
  • for Subaru XV Crosstrek 2015
  • for Subaru XV Crosstrek 2016
  • for Subaru XV Crosstrek 2017

On-The-Job Use

  • Restoring worn front suspension on daily-driven Crosstreks
  • Replacing bent or rusted arms after impact or age
  • Front-end alignment jobs requiring fresh control arms
  • Routine suspension refresh on higher-mileage vehicles

Specs At A Glance

Position Front Lower, Driver and Passenger Side
Quantity 2 Pieces
Vehicle for Subaru XV Crosstrek 2013-2017

Good To Know

Q: Do I need an alignment after installing these control arms? A: Yes, a professional alignment is recommended after replacement to restore correct camber and toe settings. Skipping it can cause rapid tire wear.

Q: Are the bushings already installed? A: The bushings come pre-installed on each arm, so no pressing is required during installation. Reuse your existing hardware unless it shows damage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Product Information

Scroll to Top