Home › Drivetrain & Belts › Clutches & CVT › 140A 12V Alternator IR‑IF SC6 Pulley For Audi A3 2010‑2013 2.0T TDI
Clutches & CVT

140A 12V Alternator IR‑IF SC6 Pulley For Audi A3 2010‑2013 2.0T TDI

Original price was: $241.49.Current price is: $72.45.
🚚 Free Shipping over $59
✓ Premium Quality
🔒 Secure Payments
↻ Money Back Guarantee
SKU: ZZ3Q01433
CATEGORY: Clutches & CVT
Description

12V Alternator for Audi A3

This 140A 12V alternator with IR-IF SC6 pulley is a replacement charging component for the Audi A3 2010-2013 2.0T TDI, delivering the amperage needed to keep the battery charged and the electrical system running.

Overview

This 140A 12V alternator is built to replace a worn charging unit on the Audi A3 2010-2013 2.0T TDI. It converts engine rotation into electrical power so the battery stays charged and accessories keep working. A solid choice for drivers facing dim lights, weak starts, or a battery warning light on the dash.

Built For Performance

  • 140 amp output supports the electrical demand of a 2.0T TDI diesel engine
  • 12 volt design matches the factory charging system voltage
  • IR-IF SC6 pulley included for direct belt-driven installation
  • Internal regulator design keeps charging voltage stable across the rev range
  • Compact housing suits the tight accessory drive layout of the A3 engine bay

Fits These Machines

  • for Audi A3 2010 2.0T TDI
  • for Audi A3 2011 2.0T TDI
  • for Audi A3 2012 2.0T TDI
  • for Audi A3 2013 2.0T TDI

On-The-Job Use

  • Restoring charging on a daily-driven Audi A3 after alternator failure
  • Replacing a noisy or seized unit before the battery drains
  • Keeping glow plugs, lights, and cabin electronics powered on diesel models
  • Servicing a high-mileage A3 during routine belt and accessory work

Specs At A Glance

Amperage 140A
Voltage 12V
Pulley Type IR-IF SC6
Application for Audi A3 2010-2013 2.0T TDI

Good To Know

Q: Will this alternator fit my A3 exactly? A: It is listed for the 2010-2013 Audi A3 2.0T TDI, but engine and pulley configurations can vary, so verify your original unit matches the 140A rating and SC6 pulley before ordering.

Q: Do I need to replace the belt at the same time? A: It is good practice to inspect the serpentine belt and tensioner whenever the alternator is removed, since worn components can cause noise or slip after the new unit goes in.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Product Information

Scroll to Top