Home › Electrical & Ignition › Switches & Sensors › 05-70-1857 05701857 Oil Pressure Sensor w/ Single Wire for Murphy ESP-100 ESP100
Switches & Sensors

05-70-1857 05701857 Oil Pressure Sensor w/ Single Wire for Murphy ESP-100 ESP100

Original price was: $34.89.Current price is: $10.47.
🚚 Free Shipping over $59
✓ Premium Quality
🔒 Secure Payments
↻ Money Back Guarantee
SKU: ZZ3F01092
CATEGORY: Switches & Sensors
Description

Oil Pressure Sensor for Murphy ESP-100

This oil pressure sensor, carrying OEM reference 05-70-1857 and 05701857, is a single-wire unit built for Murphy ESP-100 engine protection systems. It detects oil pressure and sends a signal to the ESP-100 control, enabling alarm or shutdown when pressure is low. The sensor is a direct replacement for the original part.

Overview

This oil pressure sensor for Murphy ESP-100 replaces the 05-70-1857 sender, providing reliable pressure feedback for engine shutdown protection. It is a single-wire device that connects directly to the ESP-100 controller, translating oil pressure into a measurable electrical signal. The sensor suits engines equipped with Murphy ESP-100 safety panels.

Built For Performance

  • Single wire design simplifies wiring and troubleshooting
  • Rugged construction withstands engine heat and pressure pulses
  • Direct fit for Murphy ESP-100 controller inputs
  • OEM cross-reference numbers 05-70-1857 and 05701857
  • Threaded fitting allows secure mounting

Fits These Machines

  • for Murphy ESP-100 engine protection panels
  • for Murphy ESP-100 series controllers

On-The-Job Use

  • Installed on engine oil galleries for continuous pressure monitoring
  • Common in generator sets and compressor units
  • Used in agricultural irrigation engines with ESP-100 controls
  • Applied in oilfield pumping engines

Specs At A Glance

Part Number(s) 05-70-1857, 05701857
Connection Type Single Wire
Compatible System Murphy ESP-100
Function Oil Pressure Sensing

Good To Know

Q: How do I know if this sensor matches my Murphy ESP-100 setup?A: Check that your existing sender has the same part number or cross-reference and that your controller uses a single-wire sender input. This matches the standard ESP-100 configuration.

Q: What should I do if the ESP-100 still shows a fault after replacing the sensor?A: Verify the wiring connections and ground, and check that the engine actually has sufficient oil pressure. A mechanical pressure gauge can confirm the actual pressure level.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Product Information

Scroll to Top