Home › Cooling › Radiators & Fans › Furnace Draft Inducer Blower Motor Assembly For J238-100-10108 HC21ZE121A Jakel
Radiators & Fans

Furnace Draft Inducer Blower Motor Assembly For J238-100-10108 HC21ZE121A Jakel

Original price was: $206.79.Current price is: $62.04.
🚚 Free Shipping over $59
✓ Premium Quality
🔒 Secure Payments
↻ Money Back Guarantee
SKU: ZZ3N00403
CATEGORY: Radiators & Fans
Description

Furnace Draft Inducer Blower Motor Assembly for Jakel

The Furnace Draft Inducer Blower Motor Assembly for Jakel moves combustion gases safely out of the furnace flue, cross-referencing OEM numbers J238-100-10108 and HC21ZE121A for a direct-fit replacement.

Overview

This draft inducer blower motor assembly mounts to the furnace flue to pull exhaust gases through the heat exchanger and out the vent on every heating cycle. It serves HVAC technicians and homeowners replacing a seized, noisy, or failed inducer motor. Interchangeable with J238-100-10108 and HC21ZE121A, this blower assembly restores proper draft so the furnace can run safely and efficiently.

Built For Performance

  • Cross-references OEM numbers J238-100-10108 and HC21ZE121A for matching fitment
  • Sealed motor housing resists heat and moisture inside the flue assembly
  • Balanced blower wheel keeps vibration and noise low during operation
  • Pre-assembled motor, wheel, and housing for faster installation
  • Rated for continuous duty through repeated heating cycles

Fits These Machines

  • for furnaces specifying OEM blower number J238-100-10108
  • for furnaces specifying OEM blower number HC21ZE121A

On-The-Job Use

  • Replacing a failed draft inducer on a residential gas furnace
  • Restoring proper venting when the original blower motor seizes
  • Servicing furnaces that trip on pressure switch faults
  • Routine HVAC maintenance and emergency heating repairs

Specs At A Glance

Part Number(s) J238-100-10108, HC21ZE121A
Type Draft inducer blower motor assembly
Application Furnace flue exhaust

Good To Know

Q: How do I know this blower fits my furnace? A: Match the OEM numbers J238-100-10108 or HC21ZE121A printed on your existing inducer motor or furnace data plate. Confirming the number before ordering avoids return shipping on a non-fitting part.

Q: Should I replace the gasket when installing this assembly? A: Yes, a fresh flue gasket is recommended each time the inducer is removed so combustion gases cannot leak at the mounting flange. Reuse of an old gasket can cause pressure switch faults.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Product Information

Scroll to Top