This front brake master cylinder and clutch perch assembly is a replacement setup for Honda XL600 and XL650 models, providing the hydraulic control and lever mounting point needed to keep braking and clutch operation working properly.
This front brake master cylinder and clutch perch assembly is built as a replacement for Honda XL600 and XL650 motorcycles, combining the brake fluid reservoir and piston with a perch for mounting the clutch lever. It serves riders rebuilding the handlebar controls after a crash, leak, or worn-out original unit. The assembly restores firm brake lever response and a solid mounting point for the clutch lever on XL600 and XL650 builds.
| Position | Front |
| Type | Brake master cylinder with clutch perch |
| Compatibility | Honda XL600, Honda XL650 |
| Mounting | Handlebar clamp |
Q: Will I need to bleed the brake system after installing this master cylinder? A: Yes, bleeding is required to remove air from the line and restore proper lever firmness after installation.
Q: Does this assembly come with a lever? A: Lever inclusion varies, so check the listing details and reuse your existing lever if one is not supplied.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.