This front brake master cylinder assembly is a direct-fit replacement that restores hydraulic pressure to the front brake system on your Arctic Cat 500 4×4, letting you brake with confidence again.
This front brake master cylinder assembly is built to replace a worn or leaking unit on the Arctic Cat 500 4×4, converting lever input into hydraulic pressure that actuates the front calipers. It is a straightforward swap for riders and mechanics doing routine brake service on 1998 through 2003 models. Install this front brake master cylinder assembly and get consistent, reliable stopping power back.
| Position | Front |
| Type | Master Cylinder Assembly |
| Compatible Models | Arctic Cat 500 4×4 1998-2003 |
Q: Are both left and right sides covered? A: This is a front brake master cylinder assembly, so it handles the front brake circuit on your machine. Confirm which side your model uses before ordering.
Q: Does it come with brake fluid? A: No, brake fluid is not included. You will need DOT fluid and a proper bleed after installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.