Home › Suspension, Steering & Wheels › Ball Joints & Tie Rods › For Honda Civic 2006 2007 2008 2009-2011 Steering Knuckle and Wheel Hub Bearing
Ball Joints & Tie Rods

For Honda Civic 2006 2007 2008 2009-2011 Steering Knuckle and Wheel Hub Bearing

Original price was: $329.89.Current price is: $98.97.
🚚 Free Shipping over $59
✓ Premium Quality
🔒 Secure Payments
↻ Money Back Guarantee
SKU: ZZ3M02359
CATEGORY: Ball Joints & Tie Rods
Description

Steering Knuckle and Wheel Hub Bearing for Honda Civic

This steering knuckle and wheel hub bearing assembly is a direct-fit replacement suspension component that restores proper wheel mounting and steering geometry on 2006 through 2011 Honda Civic models.

Overview

This steering knuckle and wheel hub bearing for Honda Civic combines two critical front suspension parts into one convenient assembly. The knuckle carries the hub, bearing, and brake components while the integrated wheel hub bearing keeps the wheel spinning smoothly. It is built for drivers and mechanics replacing worn or damaged front corner hardware on 2006 to 2011 Civic models.

Built For Performance

  • Durable cast steel knuckle resists cracking and flex under load
  • Pre-assembled wheel hub bearing reduces installation steps
  • Machined mounting points for accurate steering and alignment
  • Sealed bearing design keeps out road grit and moisture
  • Corrosion-resistant finish for long-term reliability
  • Direct-fit geometry matching factory mounting locations

Fits These Machines

  • for Honda Civic 2006
  • for Honda Civic 2007
  • for Honda Civic 2008
  • for Honda Civic 2009
  • for Honda Civic 2010
  • for Honda Civic 2011

On-The-Job Use

  • Front wheel bearing replacement on daily-driven Civic sedans and coupes
  • Suspension rebuilds after curb strikes or collision damage
  • Steering and alignment service on high-mileage Civics
  • Front corner restoration projects for 8th generation Civic models

Specs At A Glance

Part Type Steering knuckle with wheel hub bearing
Position Front
Fitment Years 2006 to 2011

Good To Know

Q: Is this a press-in bearing or a bolt-on hub assembly? A: This unit comes with the hub and bearing already set in the knuckle, so it bolts onto the strut and control arm without a separate press job. Always torque fasteners to factory specifications during installation.

Q: Do I need an alignment after installing this part? A: Yes, replacing a steering knuckle changes suspension geometry, so a professional alignment after installation is strongly recommended. This protects tire life and keeps steering response accurate.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Product Information

Scroll to Top