These excavator bucket pins measure 80mm by 543mm and are made from 40CR steel to secure the bucket to the arm and linkage on heavy equipment.
These excavator bucket pins are 80mm by 543mm components machined from 40CR steel for strength under load. They anchor the bucket pivot points so the attachment stays tight through digging and lifting cycles. A solid choice for operators replacing worn pins on their excavator bucket.
| Diameter | 80mm |
| Length | 543mm |
| Material | 40CR steel |
| Type | Excavator bucket pin |
Q: How do I confirm these pins fit my machine? A: Measure your existing pin diameter and length and compare them to the 80mm by 543mm spec before ordering. Serial number and linkage configuration can affect fit.
Q: Are retainers included with the pins? A: The listing covers the bucket pins themselves, so reuse or source retainers and hardware separately. Check your machine’s parts diagram for the correct retaining components.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.