This front left and right steering knuckle with integrated wheel hub bearing is a direct-fit assembly for 2006-2011 Honda Civic models, providing the pivot point for the front wheels and a mounting surface for the hub, bearing, and brake components.
This pair of front steering knuckles with wheel hub bearings is built for 2006-2011 Honda Civic owners who need to replace worn or damaged front suspension and wheel-end components. Each steering knuckle and wheel hub bearing assembly supports the wheel hub, allows the front wheels to steer, and provides mounting points for the brakes and struts. Sold as a left and right pair, this steering knuckle and wheel hub bearing set covers both sides of the front end in one order.
| Position | Front Left and Front Right |
| Included Components | Steering knuckle with wheel hub bearing, both sides |
| Vehicle Fit | 2006-2011 Honda Civic |
Q: Do I need any special tools to install this steering knuckle and wheel hub bearing pair? A: Standard hand tools plus a torque wrench and ball joint separator are typically used, and an alignment is recommended after installation. A: Confirm your Civic’s trim and year match the listed fitment before ordering.
Q: Is the wheel hub bearing already pressed into the knuckle? A: Yes, the bearing is typically pre-installed in each knuckle so the assembly can bolt on, but always inspect the bearing and hardware before installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.