Home › Engine & Rebuild › Crankshafts & Bearings › Engine Crankshaft Position Sensor for 91-95 Hyundai S coupe 3918022001 93216079
Crankshafts & Bearings

Engine Crankshaft Position Sensor for 91-95 Hyundai S coupe 3918022001 93216079

Original price was: $23.99.Current price is: $7.20.
🚚 Free Shipping over $59
✓ Premium Quality
🔒 Secure Payments
↻ Money Back Guarantee
SKU: ZZ3U00110
CATEGORY: Crankshafts & Bearings
Description

Engine Crankshaft Position Sensor for Hyundai S Coupe

This engine crankshaft position sensor replaces OEM part numbers 3918022001 and 93216079, delivering the crank position signal the engine computer needs for proper ignition timing and fuel delivery on 91-95 Hyundai S Coupe models.

Overview

This engine crankshaft position sensor is a direct replacement for 1991 through 1995 Hyundai S Coupe models, cross-referenced to OEM numbers 3918022001 and 93216079. It reads crankshaft rotation and sends the signal that keeps ignition timing and fuel injection in sync. A practical fix for rough running, hard starting, or a stored crank sensor code.

Built For Performance

  • Cross-references OEM part numbers 3918022001 and 93216079
  • Delivers a clean crank position signal to the engine computer
  • Sealed sensor body built to resist heat and oil exposure
  • Direct-fit connector matches the factory harness
  • Helps restore stable idle and smooth acceleration

Fits These Machines

  • for Hyundai S Coupe 1991-1995

On-The-Job Use

  • Replacing a failed crank sensor that causes no-start conditions
  • Fixing intermittent stalling and rough idle
  • Clearing crank position sensor trouble codes
  • Routine ignition system maintenance on older Hyundai models

Specs At A Glance

Part Number(s) 3918022001, 93216079
Type Crankshaft position sensor
Fitment Years 1991-1995

Good To Know

Q: Will this sensor fix a no-start condition? A: A failed crank sensor is a common cause of no-start and stalling issues on these engines. Confirm the fault with a diagnostic scan before replacing parts.

Q: Do I need to reset anything after installation? A: Clear any stored codes after fitting the new sensor and verify the signal with a scan tool. Check the connector and wiring for damage during the job.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Product Information

Scroll to Top