This BT40 right-angle head attaches to a CNC machining centre spindle to drive side milling and cross-hole work at up to 4000 r/min, with an ER32 collet chuck for gripping end mills and slot drills.
This BT40 angle head turns vertical spindle rotation into horizontal cutting for side milling, slotting, and drilling on part faces the main spindle cannot reach. The 90 degree layout and ER32 collet interface make it a practical accessory for machinists running BT40 tooling on vertical machining centres. It suits job shops and production cells needing a right-angle milling head without a second machine setup.
| Taper | BT40 |
| Head Angle | 90 degrees |
| Collet Type | ER32 |
| Max Speed | 4000 r/min |
Q: Does this head run at the spindle speed of the machine? A: The head is rated to a maximum of 4000 r/min, so program within that limit. Check your machine’s spindle and coolant setup before running long cycles.
Q: What tooling does the ER32 collet take? A: The ER32 chuck grips cylindrical shanks within its standard clamping range. Match your end mill or drill shank size to an ER32 collet for a secure hold.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.