This 42mm carburetor is a direct-fit replacement for the HSR42, TM42, Evo, and Evolution Twin Cam style setups, delivering the precise air and fuel metering these engines need to run clean through the whole rev range.
This 42mm carburetor is built to replace worn or clogged units on Harley Evo and Evolution Twin Cam machines that run HSR42 or TM42 style setups. It meters fuel and air into the intake tract so the engine holds a steady idle, pulls hard off the line, and keeps a clean top-end mixture. Riders and wrenchers doing a rebuild, a tune, or a straight swap will find it a practical bolt-on answer to a tired carb.
| Part Number(s) | HSR42, TM42 |
| Bore Size | 42mm |
| Style | Slide carburetor |
Q: Will this carburetor bolt straight onto my bike? A: It is built to fit HSR42, TM42, Evo, and Evolution Twin Cam style setups, but intake manifold and air cleaner matching can vary, so check your current carb mounting before ordering.
Q: Does it need jetting or tuning after install? A: Most installations benefit from a baseline idle and mixture adjustment, and final jetting often depends on altitude and exhaust setup.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.