This carb flange boot joint replaces OEM part number 4XE-13586-00-00 for Yamaha Bear Tracker 250 ATVs, sealing the carburetor intake to prevent air leaks and maintain proper air-fuel mixture.
This carb flange boot joint is a direct replacement for the OEM 4XE-13586-00-00 rubber intake boot on Yamaha Bear Tracker 250 models. It seals the carburetor to the engine, preventing vacuum leaks that cause rough idling and poor throttle response. Designed for easy installation, this boot joint restores reliable engine performance for ATV owners.
| Part Number(s) | 4XE-13586-00-00 |
Q: Can I reuse the original clamps with this boot? A: Yes, the original clamps typically work, but replacing them with new stainless steel clamps is recommended to ensure a tight seal.
Q: Should I apply sealant to the boot edges? A: No sealant is needed; the rubber-to-metal contact creates an air-tight seal when properly tightened.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.