This bulkhead connector kit provides a quick connect and disconnect point for routing LiveScope transducer cabling through a boat hull or panel, and it references 010-13350-00.
This bulkhead connector kit gives boat riggers a clean pass-through for LiveScope cable runs. The quick connect and disconnect design lets the cable be separated at the hull or panel without pulling the full run. It suits anglers and installers setting up LiveScope sonar systems.
| Part Number(s) | 010-13350-00 |
| Type | Bulkhead connector kit |
| Connection | Quick connect and disconnect |
Q: What is this bulkhead connector kit used for? A: It provides a mountable pass-through point where LiveScope cable can be connected and disconnected at the hull or panel. That keeps rigging tidy and service access quick.
Q: Does the quick disconnect affect signal performance? A: A properly seated quick connect fitting maintains a solid cable connection when joined. Confirm it is fully locked before use.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.