This black cylinder head stud kit replaces factory head bolts on 4.8L, 5.3L, and 6.0L LS-series engines, delivering consistent clamping force for high-cylinder-pressure builds.
This cylinder head stud kit is built for 97-03 Chevy LS1, LQ9, and LS6 4.8L, 5.3L, and 6.0L engines. The kit provides reusable, evenly torqued clamping hardware for the cylinder heads, suited to rebuilders, engine builders, and anyone boosting or spraying an LS platform. Each stud is finished in black for a clean, corrosion-resistant look under the hood.
| Part Type | Cylinder Head Stud Kit |
| Finish | Black |
| Engine Family | Chevy LS1, LS6, LQ9 |
| Displacements | 4.8L, 5.3L, 6.0L |
| Model Years | 97-03 |
Q: Do I need to retorque these studs after break-in? A: Follow the torque sequence from your engine builder or service manual, and check clamping load after the first heat cycle if your build calls for it.
Q: Can these be reused if I pull the heads again? A: Yes, studs are typically reusable unlike factory torque-to-yield bolts, provided threads and shanks are clean and undamaged.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.