This 7 degree tapered ball joint reamer precisely enlarges and restores worn ball joint tapers to a 1-1/2 inch per foot seat.
The 7 degree tapered ball joint reamer is a precision tool built to restore worn or egged-out ball joint tapers in steering knuckles and control arms. It removes minimal material while re-establishing the correct seat angle, ensuring a tight, slop-free ball joint fit. Vehicle and equipment technicians rely on this 7 degree ball joint reamer for front-end rebuilds that demand accurate taper geometry.
| Taper Angle | 7 Degrees |
| Taper Per Foot | 1-1/2 Inches |
Q: Does this reamer need a pilot bushing? A: It can be used with a guide but functions without one; align it carefully or use a drill press for best results.
Q: Can I use this on both upper and lower ball joints? A: Yes, it works on any 7-degree ball joint taper regardless of location, provided the stud matches the 1-1/2 inch per foot seat.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.