This drive belt replaces OEM part numbers 5100923 and 5100923SM and transfers power from the engine to the transmission on Ferris IS500Z zero-turn mowers.
The 68-inch by 5/8-inch drive belt is a critical component for Ferris IS500Z series zero-turn mowers. Made to exacting lengths, it delivers reliable power transmission from the engine pulley to the hydrostatic drive system. This replacement belt helps maintain consistent ground speed and smooth operation.
| Part Number(s) | 5100923, 5100923SM |
| Belt Length | 68 inches |
| Belt Width | 5/8 inch |
Q: How often should I replace the drive belt on my Ferris IS500Z? A: Inspect the belt every 100 hours of operation; replace if you see cracks, fraying, or glazing, or if the belt slips under load.
Q: Can I install this belt without removing the deck? A: On the IS500Z, the drive belt is accessible from above after removing the belt guards; follow your operator’s manual for safe installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.