This pack of five CAT40 45° pull stud retention knobs secures tool holders in compatible CNC machine spindles for precise machining operations.
The CAT40 45° pull stud retention knob is a critical coupling component for CNC milling setups. This set of retention knobs ensures a rigid connection between the tool holder and the machine spindle, preventing slippage during high-speed operations. Designed for machinists and operators, each CAT40 45° pull stud retention knob offers reliable pull-force transfer for consistent workpiece accuracy.
| Taper | CAT40 |
| Angle | 45 Degrees |
| Quantity | 5 Pieces |
| Finish | Silver |
Q: How often should CNC retention knobs be replaced? A: It is recommended to inspect retention knobs regularly and replace them after 2,000 to 3,000 hours of spindle time to prevent catastrophic failure.
Q: Can these be used on BT40 spindles? A: No, these are designed specifically for CAT40 spindles and will not fit BT40 configurations due to different thread and flange standards.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.