Replacement cylinder and piston ring assembly with a 51mm bore diameter compatible with OEM cross-reference numbers for Husqvarna power cutter saws.
This 51mm Cylinder Piston Ring Kit restores compression and power to the engine of compatible Husqvarna cut-off saws. The kit supplies a matched cylinder bore and piston assembly sized specifically for two-stroke power cutter applications where consistent ring seal is critical for reliable starting and full cutting RPM. Mechanics and equipment technicians use this cylinder piston ring kit to rebuild top ends on high-hour saws that have lost compression from normal ring and bore wear.
| Bore Diameter | 51mm |
| Kit Contents | Cylinder, piston, ring set, wrist pin, circlips |
| Compatible Brands | Husqvarna |
| Compatible Models | K770, K760, K760 Active II |
Q: What break-in procedure is recommended after installing this cylinder piston ring kit? A: Run the saw with a rich fuel mixture for the first two to three tanks, avoiding prolonged wide-open throttle to allow the rings to seat evenly against the cylinder wall.
Q: Can this 51mm kit be used if the original bore is worn beyond the standard size? A: The kit provides a standard 51mm bore and piston assembly intended to replace a cylinder that is still within specification for this diameter, so measure the existing bore before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.