This pair of front steering knuckles with integrated hub bearings provides the mounting and pivot point for the front wheels on 2014-2020 Ram ProMaster vehicles, letting the wheels steer and turn smoothly while the bearing carries the vertical load.
This two-piece front steering knuckle and hub bearing set is a direct-fit replacement for worn or damaged assemblies on 2014-2020 Ram ProMaster vehicles. Each knuckle locates the wheel hub and steering tie rod end, while the pressed-in hub bearing supports the wheel and allows low-friction rotation. The pair covers both the driver and passenger sides for a complete front-end refresh.
| Position | Front, driver and passenger sides |
| Quantity | 2 pieces (LH and RH) |
| Hub Bearing | Integrated, pre-installed |
Q: Do I need an alignment after installing these knuckles? A: Yes, a front-end alignment is recommended after replacing steering knuckles. Camber and toe settings should be checked once the new parts are installed.
Q: Are the hub bearings pre-pressed into the knuckles? A: Yes, this set comes with the hub bearings already installed in each knuckle. That saves time compared with pressing bearings in yourself.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.