The Dual Knock Sensors Kit (Part Number 213-3521) detects engine knock and transmits accurate voltage signals to the engine control module, designed as a direct replacement for 1999–2007 Chevy Tahoe, Suburban, and GMC models with 4.8L, 5.3L, and 6.0L V8 engines.
This Dual Knock Sensors Kit restores accurate knock detection for GM LS-based V8 engines from 1999 to 2007. It sends clean voltage signals to the ECU so timing adjustments prevent detonation and engine damage. A direct-fit solution for Chevy Tahoe, Suburban, and GMC Yukon/XL 1500 and 2500 series with 4.8, 5.3, and 6.0-liter engines.
| Part Number(s) | 213-3521 |
| Sensor Type | Piezoelectric knock sensor |
| Thread Size | M8 x 1.25 |
| Wire Harness Included | Yes (jumper harness) |
| Kit Contents | 2 knock sensors, 1 wiring harness |
| Connector Type | 2-pin flat blade |
Q: Can I install this knock sensor kit without removing the intake manifold? A: On these GM V8 engines, the knock sensors are located under the intake manifold, so removal of the intake is required for access; replacement of the intake gaskets at the same time is recommended.
Q: Will this dual sensor kit clear DTC P0332 or P0327? A: Yes, when the fault is caused by a failed sensor or corroded harness, installing this kit along with cleaning the sensor bore and applying dielectric grease often resolves those codes.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.