This 90° Trunk Spring Tool (OEM cross-reference 07AAZ-S0KA100) is a specialized service tool designed to safely remove and install trunk torsion springs on the 2007-2008 Acura TL Base 3.2L V6 Gas model, simplifying a difficult repair procedure.
This 90° Trunk Spring Tool for Acura is engineered to release and secure the high-tension trunk spring on the 2007-2008 TL, preventing injury and damage during spring removal or installation. It is an essential tool for any technician or DIYer performing trunk lid spring service, making the job quick and controlled. The tool’s angled tip matches the factory spring attachment point for a secure grip every time.
| Part Number(s) | 07AAZ-S0KA100 |
| Angle | 90 Degrees |
| Material | Forged Steel |
| Compatibility | 2007-2008 Acura TL Base 3.2L V6 Gas |
Q: Will this tool work on any other car models? A: This specific 90° Trunk Spring Tool for Acura is designed for the 2007-2008 TL Base with the 3.2L V6 gas engine, so it may not fit other vehicles. It is recommended to use it only for the intended Acura model to avoid damage.
Q: Is it safe to use without removing the trunk liner? A: The compact design allows access to the spring in many cases without full liner removal, but clearance can vary with trim. Always inspect the work area to confirm sufficient access before starting.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.