This silicone intercooler coupler hose is a 2.5 inch ID 90 degree elbow with a 3 ply reinforced wall, made to connect charge pipes and intercooler plumbing on turbocharged and forced-induction setups while resisting heat and pressure.
This 2.5 inch ID 90 degree elbow silicone coupler joins intercooler and charge pipes at a right angle where space is tight. The 3 ply reinforced construction helps the silicone coupler hose hold shape under boost and heat cycling. It suits enthusiasts and fabricators building or refreshing forced-induction plumbing, and the red finish makes routing easy to inspect at a glance.
| Inside Diameter | 2.5 in |
| Shape | 90 degree elbow |
| Construction | 3 ply reinforced silicone |
| Color | Red |
Q: Will this coupler work with any 2.5 inch charge pipe? A: It fits pipes with a 2.5 inch outside diameter and clamps are still required to secure it. Measure your pipe ends before ordering to confirm the fit.
Q: Can a silicone elbow be trimmed or used on a different angle? A: The 90 degree elbow should be used as shaped for proper pipe alignment. Cutting or reshaping the reinforced layers can weaken the coupler.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.