Home › Engine & Rebuild › Camshafts & Valvetrain › Rocker Panel Side Skirt Extension For Dodge Challenger 08-14 Left Driver Side
Camshafts & Valvetrain

Rocker Panel Side Skirt Extension For Dodge Challenger 08-14 Left Driver Side

Original price was: $147.29.Current price is: $44.19.
🚚 Free Shipping over $59
✓ Premium Quality
🔒 Secure Payments
↻ Money Back Guarantee
SKU: ZZ3T00629
CATEGORY: Camshafts & Valvetrain
Description

Rocker Panel Side Skirt Extension for Dodge Challenger

This rocker panel side skirt extension is a direct-fit lower body panel that replaces the damaged or rusted driver side rocker section and restores clean side profile lines for the 2008-2014 Challenger.

Overview

This rocker panel side skirt extension is a driver side lower body panel made to replace a damaged, dented, or rusted original rocker. The left side extension follows the body line beneath the doors and closes out the lower profile. It is aimed at Challenger owners handling collision repair, rust removal, or a full lower body refresh.

Built For Performance

  • Driver side (left) configuration matches the 2008-2014 Challenger body line
  • Direct replacement for the factory lower rocker section
  • Steel construction suitable for welding, priming, and refinishing
  • Shaped to follow the factory rocker contour for a clean straight profile
  • Sold as a single panel for the left side

Fits These Machines

  • for Dodge Challenger 2008
  • for Dodge Challenger 2009
  • for Dodge Challenger 2010
  • for Dodge Challenger 2011
  • for Dodge Challenger 2012
  • for Dodge Challenger 2013
  • for Dodge Challenger 2014

On-The-Job Use

  • Repairing rust damage along the lower driver door sill
  • Replacing dents from road debris or jack slip
  • Restoring lower body structure during collision repair
  • Prep work ahead of paint and body finishing

Specs At A Glance

Position Left (Driver Side)
Component Rocker Panel Side Skirt Extension
Vehicle Range 2008-2014 Dodge Challenger
Quantity 1 Panel

Good To Know

Q: Is welding required to install this panel? A: Yes, replacement rocker panels of this type are typically welded in place, then seam-sealed and painted. A body shop or experienced metal fabricator handles the install and finish.

Q: Does the panel come pre-painted? A: No, it arrives in bare or primed finish and needs prep, primer, and your factory color coat. Test-fit the panel before final welding or painting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Product Information

Scroll to Top