This replacement handlebar control assembly houses the fluid reservoir and lever for the brake or clutch systems on cruiser motorcycles.
The 1″ brake clutch master cylinder reservoir lever restores hydraulic response to motorcycle controls. Designed for 1-inch handlebars, this 1″ brake clutch master cylinder reservoir lever offers smooth pull and consistent pressure. Custom bike builders utilize this 1″ brake clutch master cylinder reservoir lever when refreshing a control setup.
| Handlebar Diameter | 1 inch (25mm) |
| Material | Aluminum |
Q: Does this kit contain both the brake and clutch levers? A: This single unit is designed for either the brake or clutch side as specified by the handlebar side and system type.
Q: What type of fluid is recommended for this reservoir? A: Always use the brake fluid type recommended in the motorcycle service manual, typically DOT 3 or DOT 4.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.