This rear brake master cylinder is a direct replacement hydraulic pump that pressurizes brake fluid to actuate the rear caliper on for Honda CR125R, CR250R, CRF250R, and CRF450R motocross bikes.
This rear brake master cylinder restores reliable rear braking on for Honda CR125R, CR250R, CRF250R, and CRF450R models. It converts lever input into hydraulic pressure that drives the rear caliper, giving you consistent stopping power on the track or trail. Riders doing routine maintenance or a full brake system rebuild will find this rear brake master cylinder a practical direct-fit replacement.
| Part Type | Rear Brake Master Cylinder |
| Material | Aluminum |
| Position | Rear |
| Compatibility | for Honda CR125R, CR250R, CRF250R, CRF450R |
Q: Does this come with a reservoir and lever? A: This listing covers the rear brake master cylinder unit itself, so check your existing reservoir, lever, and line fittings before installing. Reusing serviceable factory hardware is common during a master cylinder swap.
Q: Will I need to bleed the rear brake after installing it? A: Yes, any time a master cylinder is replaced the rear brake circuit must be bled to remove air. Use fresh DOT brake fluid and pump the pedal until it feels firm and consistent.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.