PCE279.1001 cylinder head stud kit cross-references OE-style head fasteners for small block Chevy engines displacing 265, 267, 283, 302, and 350 cubic inches.
This cylinder head stud kit for Small Block Chevy is built to replace factory head bolts with reusable studs and nuts for improved clamping consistency. The kit suits engine builders, racers, and rebuilders working on 265, 267, 283, 302, or 350 cubic inch SBC platforms. Each cylinder head stud kit is intended for performance assembly and teardown cycles.
| Part Number(s) | PCE279.1001 |
| Engine Family | Small Block Chevy (SBC) |
| Displacements | 265, 267, 283, 302, 350 |
| Hardware Type | Cylinder head stud kit |
Q: Do I need to retorque after installation? A: Many builders recheck torque after the first heat cycle. Follow the tightening sequence and torque specs published for your specific small block Chevy build.
Q: Can these be used more than once? A: Studs and nuts are generally reusable if threads and shanks are undamaged and torque values stay within range. Inspect each piece before reuse.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.