This oil pressure sensor adapter converts a male M16x1.5 port to a female 1/8 NPT thread, letting a standard 1/8 NPT oil pressure sender or gauge line mount to an LS engine block port.
The oil pressure sensor adapter male M16x1.5 to female 1/8 NPT is built for GM LS engine swaps where the block oil pressure port takes an M16x1.5 fitting but the sender or gauge line uses 1/8 NPT. This oil pressure sensor adapter threads into the block port on the male side and provides a female 1/8 NPT opening on the other, so aftermarket senders and mechanical gauge lines fit without drilling or retapping. It is aimed at engine swappers, builders, and anyone plumbing oil pressure instrumentation on an LS platform.
| Thread A | Male M16x1.5 |
| Thread B | Female 1/8 NPT |
| Application | GM LS engine oil pressure port |
| Material | Steel |
| Part Number(s) | M16x1.5 to 1/8 NPT |
Q: Will this adapter work for an LS swap with an aftermarket oil pressure gauge? A: Yes, the male M16x1.5 side threads into the block oil pressure port and the female 1/8 NPT side accepts a standard sender or gauge line. Confirm your sender thread is 1/8 NPT before installing.
Q: Does the adapter need thread sealant? A: Use a sealant rated for oil and heat on the male threads, keeping it clear of the sensor opening. Thread sealant on tapered NPT threads helps prevent weeping at the joint.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.